Evercoat Dura-Build Acrylic Primer Surfacer - Gray, 2274 , 1 Gallon

$149.00

A high build acrylic primer surfacer that easily fills grind marks, sand scratches and other minor surface imperfections. Sands easily to an ultra-fine finish with minimal shrinkage. Can be applied to properly prepared metal, body filler, polyester glazing putty, wood, fiberglass and aged sanded OEM topcoats.

SUBSTRATES

Properly Prepared Steel, Galvanized and Aluminum
Fiberglass
SMC
Rigid Plastics
Body Filler or Putty
Epoxy Primer
Self-Etch Primer

NOTE: For best adhesion and corrosion resistance, treat all bare metal areas larger than a quarter in diameter with a self-etch primer prior to application.

CLEANING

Surface must be clean and free of dirt, oil, grease and wax
Solvent clean all areas to be coated with a quality wax and grease remover and wipe dry with a clean, dry cloth
To solvent clean raw, exposed fiberglass, it is recommended to clean exposed area with acetone.

PREPARATION

Untreated Steel, Galvanized Steel and Bare Aluminum

Sand surface with 180 - 220 grit sandpaper. Blow off the surface with an air blow gun and solvent clean all areas to be coated with a quality wax and grease remover and wipe dry with a clean, dry cloth.
Follow paint company’s recommendations for surface prep and recoat of self-etch primer

Pre-Painted Surfaces

Sand repair area and featheredge using 80, 180, 220 and finish with 320 grit sandpaper on a random orbital sander.
Final clean with a quality wax and grease remover to remove sanding residue before priming.Sand repair area and featheredge using 180 grit, 220 grit and finish with 320 grit sandpaper on a random orbital sander
Final clean with a quality wax and grease remover to remove sanding residue prior to application

Body Filler or Putty

Finish sanding body filler or putty with 180-220 grit sandpaper
Featheredge with 320 grit sandpaper
Blow off the surface with an air blow gun

MIXING

Shake and stir thoroughly before mixing
Reduce 125% with #2296 Universal Zero VOC Reducer
Mix thoroughly before pouring primer into the gun cup

APPLICATION

Use a primer gun with a 1.4 to 1.8 fluid nozzle/air cap (Spray at paint gun manufacturer’s recommended air pressure)
Apply 2-3 medium wet coats allowing 5-10 minutes flash time between coats
FINISH
Ready to sand in about 60 minutes depending on film build
Once dry, sand with 400-600 grit sandpaper prior to next step

FINISH

Ready to sand in about 60 minutes depending on film build
Once dry, sand with 400-600 grit sandpaper prior to next step

Product# 2274 102274